Menu
Polybind Eco Seal<br>High Gloss

Polybind Eco Seal
High Gloss

Water Base Sealer
BREATHABLE • EPA-COMPLIANT • ULTRA LOW VOC

Description

Polybind Eco Seal is an acrylic copolymer used to seal concrete pavers. It penetrates deep into the concrete paver pores, thus reducing the oil and dirt penetration, as well as protecting them from the corrosion of de-icing salt.

Finish

  • High gloss
  • No color enhancement

Features

  • Helps resist corrosion from de-icing salt, ultraviolet rays effects, motor oil and grease stains
  • Works about 40°F (5°C)
  • Breathable
  • Film former
  • Joint stabilizer
  • Will not discolor
  • Rapid Installation
  • Low VOC

Helps Resist

  • Corrosion from De-Icing Salt
  • Ultraviolet Ray Effects.
  • Motor Oil & Grease Stains.

Application & Instructions

Options for Using Polybind Eco Seal:

Please Note:

  1. Most paver manufacturer’s recommend concrete pavers be sealed, 60 days after their installation date.
  2. Do not apply if rain is expected within 24 hours.
  3. Concrete paver surface must be cool to the touch.
  4. Temperature should be between 40°F (5°C) and 85°F (29°C) when sealer is applied.

Please Note:

  1. TEST the product on a small hidden area of 4 sq. ft. (0.4 sq. m.) to ensure the results will meet your expectations.
  2. Remove all the stains from the concrete pavers, using Polybind Clean products. Use Polybind Efflorescence Cleaner to remove any unknown coating that remains on the surface.
  3. Remove all contaminated jointing material and replace with Polybind Sand. Follow the latest TDS instructions found on the web site.
  4. Wait at least 48 hours at a minimum temperature of 40°F (5°C) and no rain for the Polybind Sand to properly harden.
  5. Clean the entire surface with the Polybind Efflorescence Cleaner. This product will remove the efflorescence and offer a proper sealer adhesion.
  6. Wait at least 48 hours at minimum temperature of 40°F (5°C) and no rain so the sand & concrete paver surface are dry.
  7. Best Practice: (See online video. 2 people needed.) Apply one (1) coat of Polybind Eco Seal using a sprayer in 60 sq. ft. sections, then use a water base foam roller (yellow) to remove the excess sealer or puddle left on the paved surface.
  8. Polybind Eco Seal is rain safe and could be used, after 24 hours.
    Wear protective gloves, eye protection and respiratory protection.

Alliance Designer Products shall not be liable for any non-compliant use, unless the manufacturer, distributor, or seller knows that the supplied coating would be used in a noncompliant manner.

* The container must at all times be stored at above 32°F (0°C) to receive the benefit under the Limited Warranty.

Coverage

One gallon of Polybind Eco Seal will cover 200 square feet if using one of the Polybind Eco Seal and approximately 100 square feet if using non-polymeric sand. Coverage will vary depending on joint size, thickness and porosity of the surface of the pavers. Spray on the surface and back roll with a water base foam roller (yellow) to even out the surface.

Packaging

Products Retail Size Per Box Per Pallet
Polybind Eco Seal 3.78 L (1 U.S. gal.) 4 units 24 boxes
Polybind Eco Seal 18.9 L (5 U.S. gal.) 0 units 48 units

Limited warranty

Before applying the product, the user/buyer must determine its suitability for intended use and user/buyer assumes all risks in that regard. It is a condition of the Limited Warranty that before using the product on the intended larger area, the user/buyer must first test the product on a small less observed area of approximately 4 sq. ft. (0.4 sq. m.) to ensure results meet user/buyer’s expectations. In the event that no test is carried out, the Limited Warranty will only apply to 4 sq. ft. (0.4 sq. m.).

ALLIANCE DESIGNER PRODUCTS INC. cannot guarantee results as it has no control over surface preparation and product application. If this product is proven to be defective, on the condition that it was applied pursuant to the required method of application and surface preparation, the sole obligation ALLIANCE DESIGNER PRODUCTS INC. is to refund the purchase price. Proof of purchase is required for any claim. ALLIANCE DESIGNER PRODUCTS INC. shall not be liable for any other damages whatsoever, direct or consequential. To the extent permitted by law, ALLIANCE DESIGNER PRODUCTS INC. excludes any implied warranty of quality, merchantability or fitness for purpose.

* The container must at all times be stored at above 32°F (0°C) to receive the benefit under the Limited Warranty.